Q8iv驱动模块
Q8iv-驱动模块
Q8iv-驱动模块
该驱动模块专为硅光子学设计,包含8个超精密完全可编程通道。它采用了新的卡边连接器系统,比以前的系统更易于使用且更坚固。适配器可用。现在可以使用下一代全屏蔽背板,电缆和插入器基础设施来安装新连接器。
特点:
l 8个软件定义的输入/输出通道
l 通道可配置为电压输出,电流输出,接地,电压或电流检测
l 硬件电压和电流控制(12 V,24 mA)
l 16位输出精度(±180μV,±370 nA)
l 18位输入精度
Description
This driver module, designed for silicon photonics, contains 8 ultra-precise fully programmable channels. It uses a new card-edge connector system which is easier to use and more robust than its predecessor. Adapters are available. Next-generation fully shielded backplane, cable, and interposer infrastructure to fit the new connectors are now available. Initial quantities are limited.
Features
n 8 software-defined input/output channels
n Channels configurable as voltage output, current output, ground, voltage or current sense
n Hardware voltage and current control (12 V, 24 mA)
n 16-bit output precision (±180 µV, ±370 nA)
n 18-bit input accuracy
Output circuit diagram
Referring to the diagram, nominal performance values are as follows. Values with ‘±’ are digitisation step sizes (i.e. resolution) and also target accuracy.
n a = 0..12 V ± 180 µV @ +15 mA max
n b = 0..24 mA ± 370 nA @ 15 V max
n c = 1.6 Ω max
n d = –24..+24 mA ± 740 nA
n e = 0..12 V ± 50 µV
Primary control method |
current, voltage |
Current measurement precision |
740 nA |
Maximum output current (per channel) |
24 mA |
Maximum output voltage |
12 V |
Minimum input voltage |
12 V |
Maximum input voltage |
30 V |
No. of outputs |
8 |
Electrical protection |
electrostatic discharge, programmable over-current, programmable over-voltage, reverse-polarity, short-circuit |
Current control resolution |
370 nA |
Voltage control resolution |
180 µV |
Voltage measurement precision |
50 µV |